Some programs will enable a firewall by default.Ĭheck 12: When using a router, connect the printer and computer to the LAN side (same network segment).Ĭheck 13: When the printer is connected to an AirPort Base Station via a LAN, use alphanumeric characters for the name of the network (SSID). If using any programs that switch the network environment, check their settings. If the warning message appears, set the security software to always allow access. If the firewall function of your security software is turned on, a message may appear warning that Canon software is attempting to access the network.
Make sure that the computer can communicate with the printer and the access point over the wireless LAN.Ĭheck 11: Make sure that the firewall of the security software is disabled. Place the wireless devices as far away from the interference source as possible.Ĭheck 10: Make sure that the network settings of the computer are correct. There may be a device such as a microwave oven using the same frequency bandwidth as the wireless station. 50 m from the access point.Ĭheck 9: Make sure that there is no source of radio wave interference in your vicinity. The access point is located indoors within the effective range for wireless communication. Adjust the location of the devices.Ĭheck 8: Make sure that the machine is not place as far away from the access point. Wireless communication between different rooms or floors is generally poor. Refer to the instruction manual provided with the access point or contact its manufacturer to check the access point settings, and then modify the machine settings.Ĭheck 7: Make sure that there is no obstruction. When you set up the wireless LAN connection using a USB cable or change the wireless LAN settings using IJ Network Tool, connect the machine and the computer securely.Ĭonnecting the Machine to the Computer Using a USB CableĬheck 4: Make sure that the machine setup is completed.Ĭheck 5: When using IJ Network Tool, click Update to search for the printer again.Ĭheck 6: Make sure that the network settings in the printer are identical with those of the access point. Check 1: Make sure that the machine is turned on.Ĭheck 2: Is Change wireless/wired in LAN settings under Device settings set to Disable LAN?Ĭheck 3: When the machine is connected to the computer temporarily using a USB cable, make sure that the USB cable is connected properly.
0 kommentar(er)
